Cut enough pieces of shrink tubing to completely cover each solder connection.Twist the bare strands of wire tightly on each wire end. Strip approximately 1/4 inch of insulation away from each end of each conductor.Cut each conductor to approximately 8 inches in length.Two conductors will be required one conductor for signalĬonnections, one conductor for ground connections. Should be copper, having a high strand count. Adequate wiring to connect both jacks together.The female receptacle has an inner diameter of 3.5mm, a depth of 14mmĪt the tip, and a depth no greater than 8mm for the base. One female mono plug receptacle, compatible with theĭimensions shown for the 'RealFlight Interface OutputĬonnector' as shown in the diagram.Style to the plug used on Multiplex trainer cords. One 5-pin round male connector compatible with.For all instructions, reference theĭiagram below. Transmitter interface and the InterLink controller for RealFlight. The following is a description for how to assemble anĪdapter cord to connect a Multiplex transmitter with the parallel port